FEP Quest CAD ZDSPB.com > Tech index > CAD file post > FEP Quest

Quest models!

Part: Body
Thumb
Created by: Ydna
Description: Quest body, includes barrel threads but no other threading (although most of the screw holes are obvious). This model doesn't include the angled air ports drilled beneath the solenoid.
This file was updated in March 2010 to amend a measuring error in the rear T-slot cut inside the bolt's bore.

Part: Bolt pin
Thumb
Created by: Ydna
Description: Bolt pin component, onto which the bolt slides. There's a set screw loctited into the back to seal an air port (which isn't threaded in this model).

Part: Goldmember bolt
Thumb
Created by: Ydna
Description: Goldmember bolt, slightly different from the original stock bolts.

Part: Bolt bumper
Thumb
Created by: Ydna
Description: Plastic disk bumper that sits on the bolt pin's stem.

4B Bolt Kit:
This consists of three new components, which are not compatible with any stock/OEM Quest parts.

Part: 4B bolt
Thumb
Created by: Ydna
Description: 4B bolt shaft.

Part: 4B bolt pin, rear section
Thumb
Created by: Ydna
Description: 4B bolt bolt pin, rear section only. This has female threads which allow the front section to screw into inside.

Part: 4B bolt pin, front section
Thumb
Created by: Ydna
Description: 4B bolt bolt pin, front section only. This has male threads which screw into the rear section.