These long screws hold the coil/pilot to the rest of the solenoid. The screws are 37mm long.

These short screws tighten the solenoid endcap onto the spool housing. The screws are 5mm long.

These screws are used to attach the solenoid against the marker itself. These screws are used by every marker utilising the Parker solenoid except Shocker SFTs, Shocker NXTs, and Nerves. Markers that use these screws include Shocker Sports, classic Impulses, Luxes, Defiants, and Tribals. The screws are 16mm long.
Note: the screws available here are slightly different than the ones used by markers. These screws use a flathead screwdriver instead of a Phillips head.

Replacement bottomline screws (10-32 thread) used by most markers. Choose between short length (1/2" long) or long length (7/8"). Short screws will work with just about any bottomline or rail adapter, except those with a very thick gap between the screw head and the frame.

These 5/16" long screws are used to tighten the SP S-rail mount. These will also work with the SP Angle drop (stock on Shocker SFTs and Nerves) as well as other rails or mounts that use a 5/16" length 10-32 threaded set screw to tighten.

Replacement grip panel screws for any marker using 6-32 threaded screw holes. These are available in silver or black, in varied lengths. However, the length doesn't matter when installing these on an AKA marker (since there isn't any sensitive circuitry under the screw holes).
These screws use a phillips-head screwdriver to remove and install.

Replacement screw holding the frame and solenoid tray up onto the marker body; used in both Vikings and Excaliburs. These are available in silver or black. This screw will work with all current AKALMP frames however it might not accomidate any bolt-on snatchgrips.

This is a 4-40 threaded screw that holds the 04 Viking and 04 Excalibur eye covers onto the body. If you have an older marker that had eyes/covers added by a custom shop using the prints from AKALMP, then chances are it's also 4-40 thread. Works with the JMJ eye covers. Available only in black at the moment.